Go to login fortigate external captive portal page via official link below
Login using your username and password. Login screen appears upon successful login
If you still can't access login fortigate external captive portal then see Troublshooting options or contact us for help.
In order to allow redirection to an external captive portal and also allow the supply of identifying information about the requesting IP some FortiGate configuration is required. The example below is configured using the CLI with the following attributes: WAN 1 = Internet FortiAuthenticator IP = 192.168..122
The captive portal can be hosted on the FortiGate unit or on an external authentication server. You can configure captive portal authentication on any network interface including WiFi and VLAN interfaces. When a captive portal is configured on a WiFi interface the access point initially appears open.
Fuse Fortinet User Community Home » All Forums » [Other FortiGate and FortiOS Topics] » User and Authentication » External Captive Portal with fortigate
The captive portal can be hosted on the FortiGate unit or on an external authentication server. You can configure captive portal authentication on any network interface including WiFi and VLAN interfaces. When a captive portal is configured on a WiFi interface the access point initially appears open.
Authentication Portal Local - portal hosted on the FortiGate unit. Remote - enter FQDN or IP address of external portal. User Groups Select permitted user groups or select Use Groups from Policies which permits the groups specified in the security policy. Use Groups from Policies is not available in WiFi captive portals.
Captive Portal for Compliance Failure FortiOS 6.2 replaces the endpoint compliance profile with the EMS connector. FortiGate supports a customizable captive portal to direct users to install or enable the required software. FortiOS supports per-policy custom disclaimers.
External Captive portal with Forti OS 5.2 Hi Folks I am new in this forum and not sure if this is the correct board to post this. I saw in FortiOS 5.2 release note that its support external captive portal. Have any one implement this feature with good success.
The following section describes how to configure captive or self-service portals on a per customer or per AP/controller basis. Portals can permit certain pre-login and post-login services for users including password reset and token registration abilities. Policies and access points are used to determine access to the portal.
FortiGate v5.2: Description. This article explains how to enable captive portal exempt for a specific destination address. Solution. When using captive portal authentication with WiFi SSID the "captive-portal-exempt" setting in a firewall policy can be used to exempt captive portal authentication for specific destination addresses ...
This article explains how to enable captive portal exempt for a specific destination address. A common use case is that the environment needs to have users authenticate but certain resources must be available prior authentication. Or the portal is not hosted on the FortiGate but on another device like a FortiAuthenticator.
Leave a comment